Gas Club Car Governor Adjustment: A Comprehensive Guide

Golf carts are absolutely necessary for any serious golfer. They not only make it easier for you to navigate the course, but they also give you more energy so you can concentrate on your game. 

Additionally, you must be surprised to learn that a simple golf cart governor adjustment can give you even more power and performance? 

Although it can be challenging to get it right, with the right information and comprehension, you can make your club car function flawlessly.

In this article, we’ll explain the basics of what you need to know about gas club car governor adjustment. Read thoroughly so that you don’t miss anything!  

Gas Club Car Governor Adjustment

Where is the governor on a Gas club car golf cart?

A golf cart governor mechanically controls the top speed. You can unwind without worrying because this practical device keeps engine RPMs within safe limits.

However, you can change the governor to generate more speed as desired. The thickest cable from the gas pedal should be followed to find the governor of gas club cars.

This cable climbs the engine’s side, passes through the governor, and then travels to the carburetor. Look next to the fuel tank under the passenger seat to find the governor.

Tools Required To Adjust The Golf Cart Governor

If you’re looking to take your golf cart to the next level, you’ll need some essential tools to adjust your golf cart governor. 

  • Suitable screwdriver
  • An adaptable wrench
  • Knife or Cutter 
  • Metric sockets and drive tools 
  • A speedometer driving tool 
  • Needle-nose pliers 

With these tools, you’ll be able to make the perfect adjustments to your golf cart governor, giving you the power and speed you need to have a great round of golf.

Precaution to take when adjusting Gas Club Car Governor

First and foremost, read the manual that came with your Club Car golf cart thoroughly. This will give you the information you need to adjust the governor precisely.

Before you set out, check the engine oil and battery fluid levels. This will ensure that your car is running at peak performance. 

Things To Ensure

Things To Ensure
  • Remove the Key: Before adjusting the governor on your Club Car golf cart, remove the key from the ignition. 
  • Disconnect the Battery: Locate and disconnect the battery’s negative terminal before you make any adjustments. 
  • Use Protective Gear: When handling any electrical components, it is important to wear rubber gloves or wrap a cloth around your hand.

Evaluate The Dangers

Avoid the temptation to alter or remove the governor from your golf cart unless you are aware of the dangers.

Your warranty will be voided if you do this, and if the cart is driven at excessively high speeds, it may result in serious engine damage. 

These carts were designed to go 12-15 mph, and any higher speed can be dangerous. Also, adjusting the governor will not be very effective when it comes to slow operations. 

After ensuring these, you can adjust the governor on your Club Car golf cart with confidence and safety. Make sure to keep these tips in mind before you set out on the course!

How To Adjust The Governor On A Club Car Golf Cart?

If your engine runs too fast or too slow, you can adjust the governor to get the speed you want. The task is fairly easy. Here’s a guide on how to adjust the governor in five simple steps. 

Step 1: Locate and Remove the Governor

Locate and Remove the Governor

The governor is located under the passenger seat in the fuel tank. You’ll need to remove any plastic or metal pieces that are blocking it.

Use a butter knife to remove the clips holding it in place. Then, loosen two screws with an Allen wrench. 

Step 2: Prepare the Golf Cart

Prepare the Golf Cart

Before adjusting the governor, make sure to disconnect any aftermarket parts. This includes engine block heaters and battery warmers. Also, disconnect your battery and wait at least 90 seconds before proceeding.

Step 3: Adjust the Governor

Adjust the Governor

Follow the thickest cable coming from the gas pedal until you find a small spring wrapped around a metal rod.

This is the governor. It is attached to the cart’s carburetor with two nuts, one big and one small. 

Loosen the small nut and tighten the larger nut in quarter-turn increments. This will increase the speed of your cart, but be careful not to over-stress the engine.

If you do, it may skip or even burn out. Once the speed is adjusted to your satisfaction, tighten the small nut backup to keep the spring secured.

Step 4: Put the Golf Cart to the Test

Put the Golf Cart to the Test

Turn your key to the ON position and wait at least three seconds before pressing down on the accelerator pedal. You’re good to go if your golf cart’s engine revs up. 

Monitor the cart for whining, skipping, or clunking noises, which indicate the governor is too tight. If this happens, loosen the nut slightly until the noise reduces.

Step 5: Reassemble Everything

Reassemble Everything

Now that you’ve fixed the issue, it’s time to put it back together. Begin by repositioning everything to its original place and securing it with screws. 

By adjusting the governor on your Club Car gas golf cart, you can optimize its performance. You can quickly get the job done with the five steps listed above without a hitch.

FAQs.

Now that you know everything about the gas golf cart governor and governor adjustment, here are some frequently asked questions to clear up your further doubts!

Why is my club car becoming slow?

The most common cause of golf carts slowing down is a lack of power output from the battery. If your cart’s battery pack charge is very low and it is out of power, it will run slowly.

Why does a gas golf cart have a speed sensor?

The speed sensor in your cart is an important component that lets the cart know how fast it’s moving.
Additionally, it can transmit data on engine RPM and other intricate aspects of your cart’s operation, enabling it to function more effectively.

Which is the more powerful gas or electric golf cart?

Electric carts are less powerful than gas carts. In terms of durability, gas carts outlast electric carts. Also, gas carts are less expensive because you don’t need to replace the batteries every 5 years.

Does lifting a golf cart make it faster?

A lifted golf car usually means replacing the stock tires with larger ones. These tires are faster than regular tires. The difference in speed ranges from a few miles per hour to 20 miles per hour.

Conclusion

Gas club car governor adjustment is a fantastic way to get the most out of your golf cart. If you are dissatisfied with the speed of your favorite golf cart, you can now adjust it using the steps outlined in this blog.

But, like any other hack, there are some drawbacks. If you put too much strain on your engine, it may fail, and losing the warranty may cause you problems. 

Therefore, think twice before acting. However, we believe a minor adjustment within the safe limit to get more in your cart is worthwhile!

Similar Posts